Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 32)

22 GE MDS entraNET Reference Manual 05-4055A01, Rev. D

NOTE: The exact parameters given above must be used for console

terminal communication. Improper settings are a common

cause of difficulty.

Telnet Connection

Using the AP LAN

Port (a valid IP

address must be set)

To configure the AP via its LAN port:

1. Connect a PC Ethernet port to the AP with an Ethernet crossover

cable.

NOTE: The radio must first have a valid IP address programmed—the

default IP address is 192.168.1.1.

2. Log in to the AP as follows:

a. Press the key to receive the login prompt. The COM1/LAN

LED flashes to indicate data communications.

a. At the login prompt, enter the username (admin is the default

username). Press .

b. At the Password prompt, enter the password (admin is the default

password). Press . Upon successful log-in, the Starting

Information Screen appears.

3. Review the current menu settings and make any necessary changes.

Refer to Set Key AP Parameters on Page 22 for

configuration guidance.

4. Repeat Steps 1–3 for any other AP radios in your system.

NOTE: You can save time by using configuration scripts to uniformly

configure multiple transceivers. This technique is discussed in

the Configuration Scripts Menu on Page 87.

Set Key AP Parameters

Table 2-1 provides a listing of key AP operating parameters, their

default settings, and their values or range. Typically, these are the only

settings that need to be set or reviewed for a basic check of the radio

system. A complete list of AP commands appears in CHAPTER 3 AP

MANAGEMENT, beginning on Page 29.

ENTER

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 219 220

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 32