Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 135)

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 127

8.1 DATA INTERFACE CONNECTORS

Three types of data interface connectors are used on entraNET trans-

ceivers. The first, the LAN Port, is a metallized RJ-45 connector. The

other two are standard modular types—RJ 12 for the COM1 port, and

RJ-45 for the COM2 port. This section provides illustrations and pinout

information for all of these data connectors.

The transceiver meets U.S.A.’s FCC Part 15, Class A limits when used

with shielded data cables not exceeding 3 feet/0.9 meters in length.

8.1.1 Ethernet/LAN Port (AP, Ethernet Remote)

This port is used to connect to an Ethernet network at an AP or to the

endpoint of a Remote.

• To connect a PC directly to the AP’s Ethernet port, an RJ-45 to

RJ-45 cross over cable is required. At the Remote, a straight

through cable is required.

• To connect the AP to a Ethernet hub or bridge, use a

straight-through cable.

The connector uses standard Ethernet RJ-45 cables and wiring. The

pinout information below may be used to construct a custom cable, if

required.

Figure 8-1. LAN Port (RJ-45) Pinout

(Viewed from the outside of the unit)

Pin Functions Ref.

1 Transmit Data (TX) High

2 Transmit Data (TX) Low

3 Receive Data (RX) High

4 Unused

5 Unused

6 Receive Data (RX) Low

7 Unused

8 Unused

CAUTION

RADIO

INTERFERENCE

POTENTIAL

1 2 3 4 5 6 7 8

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 135