Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 55)

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 47

• Inter-Packet Delay— Number of characters that rep-

resent the end of a message (inter-character time-out). A

transceiver receiving data through the serial port will send an

end-of-message signal to the remote end. MODBUS defines

a “3.5-character” parameter. [0–1,000; 0]

3.5.3 Remote Serial Gateway Configuration

(IP-to-Remote Serial)

The serial gateway controls the behavior of all Remote radios from the

perspective of IP encapsulation. The gateway is basically a table with

one entry for each Serial Remote radio. Ethernet radios are not defined

in the serial gateway. No further configuration is required at the Remote

radios.

The AP can be configured to accept IP traffic to be exchanged with

devices connected to the serial ports of one or more Remotes.

Figure 3-19 shows the starting point for configuring the Remote Serial

Gateway settings.

Invisible place holder

Figure 3-19. Serial Configuration for Remote Radios

• RSG Talkback Enable (UDP IP-to-Serial)—When this

option is enabled, and the RSG is set up for UDP mode, a

message from a Remote radio (usually a reply to a poll) will

be sent to the last IP address/port that a message was received

from.

• RSG Talkback Timeout—After this timeout has

expired (time since the last data has been received from an IP

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 55