Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 98)

90 MDS entraNET 900 System Guide MDS 05-4055A01, Rev. A

RADIO

[UNIT=<unit>, NETADDR=<netaddr>, PWR=<pwr>, SYNC=, RSSI=,

CONN=<conn>, AP=, REFRESH=<refresh>, CMD=<cmd>]

This command sets / displays the radio configuration and status.

Optional Arguments:

UNIT=<unit>—32-bit user-programmable unit address. Defaults to serial

number but is user programmable.

NETADDR=<netaddr>—Current Radio Network Address. Acceptable

value range is 0–32637

PWR=<pwr>—Current Radio Power Setting. Value is in dBm with an

acceptable range of 20–30.

SYNC= Read only. Shows current state of radio synchronization.

RSSI= Read only. Shows Received Signal Strength (RSSI). Value is

shown in dBm with a range of -120 to 0. This value is refreshed every

three seconds.

CONN=<conn>—Determines whether the device (Remote) has associated

with an Access Point.

NOT ASSOCIATED: Remote radio not associated with an AP

ASSOCIATED: Remote radio associated with an AP

AP= Read only. Shows associated AP’s Serial Number. Acceptable

value range is 1–99999999

REFRESH=<refresh>—Read only. Connection refresh period in seconds

with an acceptable value range of 0–255

REBOOT

[REBOOT, SAME, OTHER, APP1, APP2]

This command is used to reboot the radio's firmware.

Optional Arguments:

SAME—Same Image

OTHER—Other Image

APP1—Application Image 1

APP2—Application Image 2

SLEEP

[SLEEP, MODE=<mode>, WAKE=<wake>, DTRSENSE=<dtrsense>, PERIOD=<pe-

riod>, HANGTIME=<hangtime>, CMD=<cmd>]

This command sets/displays one of the low power operating modes the

Remote radio will operate under. These modes are commonly used in

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 98