Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 21)

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 13

2.1 INTRODUCTION

Prior to field installation, it is recommended that the radio system be set

up in a controlled environment to become familiar with its operation. A

tabletop network can be established to verify the basic operation of the

system and allow tests of various network designs and configurations.

Such a test can be performed with any number of radios.

This section describes the hardware setup and software configuration

needed for a tabletop test. To simulate data traffic over the radio net-

work, a PC or LAN will be connected to the Ethernet port of the Access

Point and used to poll each Remote transceiver several times.

NOTE: For on-the-air testing, it is important to use a radio system

Network Address and device IP addresses that are different

from any currently in use in your region or network. This elim-

inates disruption to traffic on existing systems while you are

testing the radios.

One technique for minimizing the chance of radio network

address conflicts, is to use the last four digits of the radio’s

serial number.

2.1.1 Connector Overview

The illustrations below provide a reference to all of the interface connec-

tors present on entraNET transceivers. A review of these items will

assist you in making the connections described in the steps that follow.

Figure 2-1 shows the interface connectors for the Access Point trans-

ceiver.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 21