Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 27)

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 19

Invisible place holder

Figure 2-7. Remote Configuration Setup

Follow these steps to login to the radio.

1. Press a few keystrokes to receive the

entranet> prompt. (The

COM1/ETH LED blinks to indicate data communication.)

2. At the

entranet> prompt, type login. Press .

3. At the next prompt, enter username (default username is admin).

Press .

4. At next prompt, enter Password (default password is admin). Press

. The unit is now ready to accept commands.

Set/Verify Network Address

The only setting normally required for initial checkout of a Remote

radio is the Network Address. All radios in a given network must be pro-

grammed with the same network address as the AP or communication

will not be possible. Follow the steps below to check the address, and

program a new one if necessary.

1. Enter the

RADIO NETADDR command. This displays the radio’s

currently programmed network address.

2. If changes are required, enter the

RADIO NETADDR= <netaddr> com-

mand, where

<netaddr> is a number from 1 to 20000. (The network

address of the Remote radio must match that of the AP.)

3. Verify that the

LINK LED lights to indicate successful connection

with the AP. (It may take several seconds for the LED to light).

4. Repeat Steps 1–3 for each Remote radio to be installed in the net-

work.

PC Running Terminal Session

(19,2000 bps, 8N1)

Remote

COM1 Port

ENTER

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 27