Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 8)

vi MDS entraNET 900 System Guide MDS 05-4055A01, Rev. A

The transceiver has been recognized for use in these hazardous locations by two independent agencies —Underwriters

Laboratories (UL) and the Canadian Standards Association (CSA). The UL certification for the transceiver is as a Rec-

ognized Component for use in these hazardous locations, in accordance with UL Standard 1604. The CSA Certifica-

tion is in accordance with CSA STD C22.2 No. 213-M1987.

UL/CSA Conditions of Approval: The transceiver is not acceptable as a stand-alone unit for use in the hazardous

locations described above. It must either be mounted within another piece of equipment which is certified for

hazardous locations, or installed within guidelines, or conditions of approval, as set forth by the approving agencies.

These conditions of approval are as follows:

The transceiver must be mounted within a separate enclosure which is suitable for the intended application.

The antenna feedline, DC power cable and interface cable must be routed through conduit in accordance with the

National Electrical Code.

Installation, operation and maintenance of the transceiver should be in accordance with the transceiver's installation

manual, and the National Electrical Code.

Tampering or replacement with non-factory components may adversely affect the safe use of the transceiver in haz-

ardous locations, and may void the approval.

A power connector with screw-type retaining screws as supplied by MDS must be used.

Do not disconnect equipment unless power has been switched off or the area is known to

be non-hazardous.

Refer to Articles 500 through 502 of the National Electrical Code (NFPA 70) for further

information on hazardous locations and approved Division 2 wiring methods.

FCC Part 15 Notice

The transceiver complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including inter-

ference that may cause undesired operation. This device is specifically designed to be used under Section 15.247 of

the FCC Rules and Regulations. Any unauthorized modification or changes to this device without the express approval

of Microwave Data Systems may void the user’s authority to operate this device. Furthermore, this device is intended

to be used only when installed in accordance with the instructions outlined in this manual. Failure to comply with these

instructions may also void the user’s authority to operate this device.

Manual Revision and Accuracy

While every reasonable effort has been made to ensure the accuracy of this manual, product improvements may result

in minor differences between the manual and the product shipped to you. If you have additional questions or need an

exact specification for a product, please contact our Customer Service Team using the information at the back of this

guide. In addition, manual updates can often be found on the MDS Web site at www.microwavedata.com.

EXPLOSION

HAZARD!

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 8