Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 17
- Pagina / 148
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 9
1.3.1 Intrusion Detection via SNMP Traps
(Available soon)
In addition to the operative tools and techniques, future releases of the
MDS entraNET 900 will provide SNMP-based network management
systems with traps (alarms) that report suspicious activities or events.
These will include:
• Unauthorized AP serial number detected at Remote
• Unauthorized Remote serial number detected at AP
• Login attempt limit exceeded
(Accessed via: Telnet, HTTP, or local)
• Successful login/logout
(Accessed via: Telnet, HTTP, or local)
1.4 ACCESSORIES
MDS entraNET transceivers may be used with one or more of the acces-
sories listed in Table 1-3. Contact the factory for ordering details.
Denial of service, where Remote radios
could be reconfigured with bad
parameters bringing the network down.
✓ Remote login
✓ Local console login
✓ Disabled HTTP & Telnet to allow
only local management services
Airsnort and other war-driving hackers in
parking lots, etc.
✓ 900 MHz FHSS does not talk over
the air with standard 802.11b cards
✓ The transceiver cannot be put in a
“promiscuous” mode
✓ Proprietary data framing
Eavesdropping, intercepting messages
✓ 128-bit encryption
Key cracking
✓ Automatic Rotating Key algorithm
Replaying messages
✓ 128-bit encryption with rotating
keys
Unprotected access to configuration via
SNMP (available soon)
✓ Will enable/disable non-secure
SNMP versions
✓ Will password-protect SNMPv3
Potential, ongoing attacks
✓ Provides early warning via SNMP
through critical event reports
(unauthorized, logging attempts,
etc.)
Table 1-2. Security Risk Management
Security Risk The MDS entraNET 900 Solution
- MDS entraNET 1
- Contents 3
- RF Exposure 7
- INTRODUCING THE 9
- 1.1 PRODUCT DESCRIPTION 11
- 1.2 APPLICATIONS 13
- Serial Interfaces 15
- 1.4 ACCESSORIES 17
- Table 1-3. Accessories 18
- TEST SETUP AND 19
- EVALUATION 19
- 2.1 INTRODUCTION 21
- 2.2 STEP 1—CONNECT THE 23
- ANTENNA PORTS 23
- Wire Ports 24
- COM1 or LAN Port 25
- (See Text) 25
- COM1 port 26
- COM1 Port 27
- 2.5 STEP 4—CONNECT TERMINAL 28
- EQUIPMENT 28
- 2.6 STEP 5—CHECK FOR NORMAL 28
- OPERATION 28
- 2.6.1 Verifying Connectivity 29
- Figure 2-8. Ping Test Setup 30
- AP MANAGEMENT 31
- 3.1 INTRODUCTION 33
- (Telnet Similar) 36
- COM1 port via a serial cable 37
- 3.1.4 Navigating the Menus 39
- 3.2 BASIC DEVICE INFORMATION 40
- 3.2.2 Main Menu 41
- 3.3 CONFIGURING NETWORK 42
- PARAMETERS 42
- From Access Point 43
- 3.3.2 IP Configuration Menu 44
- (User Review Required)—ID of 45
- 3.4 CONFIGURING RADIO 48
- Figure 3-13. Skip Zones Menu 49
- 3.5 CONFIGURING THE SERIAL 50
- INTERFACES 50
- Serial Data Port 51
- (Serial-to-Serial example) 53
- (IP-to-Serial Example) 53
- COM port in 54
- 3.6 SECURITY CONFIGURATION 57
- 3.7 WIRELESS NETWORK MENU 59
- Figure 3-26. Remote Database 62
- 3.8 STATISTICS/EVENT LOG 64
- Wireless Packet 68
- Statistics 68
- Ethernet Packet 68
- 3.8.4 Radio Packet Statistics 69
- 3.8.5 Event Log Menu 69
- Time and Date 70
- Figure 3-34. Event Log Menu 70
- (Telnet/Terminal only)—IP 71
- 3.9 DEVICE INFORMATION MENU 72
- 3.10 MAINTENANCE/TOOLS 73
- 3.10.1Reprogramming Menu 74
- Upgrading the 76
- Transceiver 76
- Firmware 76
- LAN, or Terminal emulator 77
- 3.10.3 Ping Utility Menu 85
- 3.10.4Authorization Keys Menu 86
- MANAGEMENT 87
- REMOTE RADIO 87
- 4.1 INTRODUCTION 89
- COMMAND DESCRIPTION 90
- 4.2 UPGRADING REMOTE FIRMWARE 101
- CONFIGURATIONS 103
- Establishing a 105
- Connection 105
- Invisible place holder 106
- RemoteAccess Point 107
- COM port 108
- Remote 1 109
- Remote 2 109
- Remote 3 109
- Remote 4 109
- Access Point 109
- INSTALLATION 111
- 6.1 INSTALLATION 113
- 6.1.2 Site Selection 114
- High-gain Type 115
- Unity-gain Type 115
- CHART, on Page 113 120
- TROUBLESHOOTING & 123
- RADIO TESTS 123
- 7.1 TROUBLESHOOTING 125
- Management System 126
- LINK LED 130
- Statistics) 131
- TECHNICAL REFERENCE 133
- 8.1 DATA INTERFACE CONNECTORS 135
- 8.1.2 COM1 Port (AP, Remotes) 136
- 8.2 TECHNICAL SPECIFICATIONS 137
- DATA CHARACTERISTICS 138
- RADIO CHARACTERISTICS 138
- DEFINITIONS OF TERMS 141
- COM1 and COM2 Port of the 142
- IN CASE OF DIFFICULTY 147
Relacionado con productos y manuales para Redes Microwave Data Systems MDS entraNET 2400
(220 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.030 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales