Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 18
- Pagina / 148
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
10 MDS entraNET 900 System Guide MDS 05-4055A01, Rev. A
Table 1-3. Accessories
Accessory Description MDS Part No.
AC Power
Adapter Kit
A small power supply module designed for
continuous service. UL approved. Input:
120/220; Output: 13.8 Vdc @ 2.5 A
01-3682A02
Omni-
Directional
Antennas
Rugged antennas well suited for use at Access
Point installations. Consult with your factory
Sales Representative for details
Contact factory
Yagi Antenna
(Directional)
Rugged antennas well suited for use at Remote
installations. Consult with your factory Sales
Representative for details.
Contact factory
TNC Male-to-N
Female Adapter
One-piece RF adaptor plug. 97-1677A161
TNC Male-to-N
Female Adapter
Cable
Short length of coaxial cable used to connect
the radio’s TNC antenna connector to a Type N
commonly used on large diameter coaxial
cables.
97-1677A159
(3 ft./1m)
97-1677A160
(6 ft./1.8m)
2-Pin Power
Plug
Mates with power connector on transceiver.
Screw terminals provided for wires, threaded
locking screws to prevent accidental
disconnect.
73-1194A39
Ethernet RJ-45
Straight-thru
Cable (CAT5)
Cable assembly normally used to connect an
Ethernet device or LAN to the transceiver. Both
ends of the cable are wired identically.
(Cable length ≈ 3 ft./1M)
97-1870A20
Ethernet RJ-45
Crossover
Cable (CAT5)
Cable assembly used to connect an AP to an
Ethernet endpoint. (Cable length ≈ 3 ft./1M)
97-1870A21
RJ-12 to DB-9
Female Adapter
Allows access to Data Serial port COM1 on
Remotes or APs.
73-2434A02
RJ-45 to DB-9
Female Adapter
Allows access to Data Serial port COM2 on
Remotes or APs.
73-2434A12
EIA-232
Shielded Data
Cable
Shielded cable terminated with a DB-9 male
connector on one end, and a DB-9 female on
the other end, 6 ft./1.8m long.
97-1971A03
Fuse Small, board-mounted fuse used to protect
against over-current conditions.
29-1784A03
Flat-Surface
Mounting
Brackets &
Screws
Brackets: 2˝ x 3˝ plates designed to be screwed
onto the bottom of the unit for surface-mounting
the radio.
82-1753-A01
Screws: 6-32/1/4˝ with locking adhesive.
(Industry Standard MS 51957-26)
70-2620-A01
DIN Rail
Mounting
Bracket
Bracket used to attach the transceiver to
standard 35 mm DIN rails commonly found in
equipment cabinets and panels.
03-4022A01
(Remote)
03-4022A02
(Access Point
- MDS entraNET 1
- Contents 3
- RF Exposure 7
- INTRODUCING THE 9
- 1.1 PRODUCT DESCRIPTION 11
- 1.2 APPLICATIONS 13
- Serial Interfaces 15
- 1.4 ACCESSORIES 17
- Table 1-3. Accessories 18
- TEST SETUP AND 19
- EVALUATION 19
- 2.1 INTRODUCTION 21
- 2.2 STEP 1—CONNECT THE 23
- ANTENNA PORTS 23
- Wire Ports 24
- COM1 or LAN Port 25
- (See Text) 25
- COM1 port 26
- COM1 Port 27
- 2.5 STEP 4—CONNECT TERMINAL 28
- EQUIPMENT 28
- 2.6 STEP 5—CHECK FOR NORMAL 28
- OPERATION 28
- 2.6.1 Verifying Connectivity 29
- Figure 2-8. Ping Test Setup 30
- AP MANAGEMENT 31
- 3.1 INTRODUCTION 33
- (Telnet Similar) 36
- COM1 port via a serial cable 37
- 3.1.4 Navigating the Menus 39
- 3.2 BASIC DEVICE INFORMATION 40
- 3.2.2 Main Menu 41
- 3.3 CONFIGURING NETWORK 42
- PARAMETERS 42
- From Access Point 43
- 3.3.2 IP Configuration Menu 44
- (User Review Required)—ID of 45
- 3.4 CONFIGURING RADIO 48
- Figure 3-13. Skip Zones Menu 49
- 3.5 CONFIGURING THE SERIAL 50
- INTERFACES 50
- Serial Data Port 51
- (Serial-to-Serial example) 53
- (IP-to-Serial Example) 53
- COM port in 54
- 3.6 SECURITY CONFIGURATION 57
- 3.7 WIRELESS NETWORK MENU 59
- Figure 3-26. Remote Database 62
- 3.8 STATISTICS/EVENT LOG 64
- Wireless Packet 68
- Statistics 68
- Ethernet Packet 68
- 3.8.4 Radio Packet Statistics 69
- 3.8.5 Event Log Menu 69
- Time and Date 70
- Figure 3-34. Event Log Menu 70
- (Telnet/Terminal only)—IP 71
- 3.9 DEVICE INFORMATION MENU 72
- 3.10 MAINTENANCE/TOOLS 73
- 3.10.1Reprogramming Menu 74
- Upgrading the 76
- Transceiver 76
- Firmware 76
- LAN, or Terminal emulator 77
- 3.10.3 Ping Utility Menu 85
- 3.10.4Authorization Keys Menu 86
- MANAGEMENT 87
- REMOTE RADIO 87
- 4.1 INTRODUCTION 89
- COMMAND DESCRIPTION 90
- 4.2 UPGRADING REMOTE FIRMWARE 101
- CONFIGURATIONS 103
- Establishing a 105
- Connection 105
- Invisible place holder 106
- RemoteAccess Point 107
- COM port 108
- Remote 1 109
- Remote 2 109
- Remote 3 109
- Remote 4 109
- Access Point 109
- INSTALLATION 111
- 6.1 INSTALLATION 113
- 6.1.2 Site Selection 114
- High-gain Type 115
- Unity-gain Type 115
- CHART, on Page 113 120
- TROUBLESHOOTING & 123
- RADIO TESTS 123
- 7.1 TROUBLESHOOTING 125
- Management System 126
- LINK LED 130
- Statistics) 131
- TECHNICAL REFERENCE 133
- 8.1 DATA INTERFACE CONNECTORS 135
- 8.1.2 COM1 Port (AP, Remotes) 136
- 8.2 TECHNICAL SPECIFICATIONS 137
- DATA CHARACTERISTICS 138
- RADIO CHARACTERISTICS 138
- DEFINITIONS OF TERMS 141
- COM1 and COM2 Port of the 142
- IN CASE OF DIFFICULTY 147
Relacionado con productos y manuales para Redes Microwave Data Systems MDS entraNET 2400
(220 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.088 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales