Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 38)

30 MDS entraNET 900 System Guide MDS 05-4055A01, Rev. A

Procedure with

Terminal Emulator

a. Connect a computer’s serial communications port to the trans-

ceiver’s

COM1 Port connector.

b. Launch a terminal emulator program, such as HyperTerminal, on

the computer. Conﬁgure it to 19,200 bps data rate, 8-bit charac-

ters, no parity, one stop bit, and no ﬂow-control. Use ANSI or

VT100 emulation.

c. Press the

ENTER key. A login screen will be displayed that

requires a user name and password to access the Management

System. (User =

admin; default password = admin)

The radio will respond with a login screen, followed by the

start-up screen similar to Figure 3-5 on Page 29.

NOTE: If the transceiver is powered-up or rebooted while connected

to a terminal, you will see a series of pages of text information

relating to the booting of the unit’s microcomputer. Wait for

the initial entraNET MS login screen before proceeding. The

boot process takes approximately 30 seconds.

Procedure with

Telnet (AP only)

a. Connect a personal computer’s Ethernet port to the LAN Port

connector on the AP transceiver using an Ethernet crossover

cable or connect the AP to the network. (See Figure 2-1 on

Page 14 for location.) The

LAN LED will light to indicate an

active connection.

b. Start the Telnet program on your computer targeting the IP

address of the transceiver to which you are connected and press

the

ENTER key.

For example, in Windows: Start>Run>Telnet

NOTE: Do not connect multiple transceivers with the default IP

address (192.168.1.1) to the network.

c. The transceiver will respond with a login screen. Enter your

username and password. (Default =

admin)

The entraNET responds with the start-up menu screen.

(Figure 3-6 on Page 32)

Procedure with Web

Browser (AP only)

a. Connect a personal computer’s Ethernet port to the LAN Port

connector on the transceiver using an Ethernet crossover cable.

(See Figure 2-1 on Page 14 for location.) The

LAN LED will

light to indicate an active connection.

b. Launch a Web-browser on your computer.

c. Type in the radio’s IP address. For example

192.168.1.1 and press

the

ENTER key. (Default address = 192.168.1.1)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 147 148

Comentarios a estos manuales

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Microwave Data Systems MDS entraNET 2400