Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 77
- Pagina / 148
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 69
Invisible place holder
Figure 3-41. Upgrade Configuration—Option 2
(TFTP Server and Firmware File on Remote Server)
NOTE: Transferring the radio firmware image file (≈ 3 Mb), may take
several minutes depending on traffic between the TFTP server
and the transceiver.
Regardless of your connection to the transceiver, loading firm-
ware/configuration files into the unit’s flash-RAM is much
slower than loading software onto a PC hard drive or RAM.
Upgrade Procedure To upgrade the transceiver’s firmware file (filename.gpk) use the fol-
lowing procedure:
1. Launch a TFTP server on a PC connected either directly or via a
LAN to the Ethernet port (
LAN) of the transceiver. Configure the
server to allow downloads from the directory containing the
firmware image file.
2. Connect to the entraNET Management System by whichever means
is convenient: Browser or Telnet via the
LAN, or Terminal emulator
via the
COM1 port.
3. Go to the entraNET MS Reprogramming Menu.
(Main Menu>Maintenance Menu>Reprogramming Menu)
4. Fill in the information for the following:
• TFTP Host Address—IP Address of server (host com-
puter) running TFTP server.
• Retrieve File—Name of file (filename.gpk) to be pulled
from the TFTP server holding the firmware file.
TFTP
SERVER
ETHERNET
PORT
COM1
PORT
(DCE)
INITIATE UPLOAD
FROM HERE
REMOTE PC
W/FIRMWARE FILES
HUB/LAN/WAN/MAN
TCP/IP
LAN
PORT
COM1, 2, ETC.
(DTE)
IP ADDRESS: 192.168.0.10.0
LOCAL PC
ACCESS POINT
IP ADDRESS: 192.168.0.1
T
E
R
M
IN
A
L
P
R
O
G
R
A
M
9
-
P
I
N
S
E
R
I
A
L
C
A
B
L
E
W
/
R
J
-
1
2
A
D
A
P
.
L
A
N
C
O
M
1
C
O
M
2
P
W
R
L
I
N
K
- MDS entraNET 1
- Contents 3
- RF Exposure 7
- INTRODUCING THE 9
- 1.1 PRODUCT DESCRIPTION 11
- 1.2 APPLICATIONS 13
- Serial Interfaces 15
- 1.4 ACCESSORIES 17
- Table 1-3. Accessories 18
- TEST SETUP AND 19
- EVALUATION 19
- 2.1 INTRODUCTION 21
- 2.2 STEP 1—CONNECT THE 23
- ANTENNA PORTS 23
- Wire Ports 24
- COM1 or LAN Port 25
- (See Text) 25
- COM1 port 26
- COM1 Port 27
- 2.5 STEP 4—CONNECT TERMINAL 28
- EQUIPMENT 28
- 2.6 STEP 5—CHECK FOR NORMAL 28
- OPERATION 28
- 2.6.1 Verifying Connectivity 29
- Figure 2-8. Ping Test Setup 30
- AP MANAGEMENT 31
- 3.1 INTRODUCTION 33
- (Telnet Similar) 36
- COM1 port via a serial cable 37
- 3.1.4 Navigating the Menus 39
- 3.2 BASIC DEVICE INFORMATION 40
- 3.2.2 Main Menu 41
- 3.3 CONFIGURING NETWORK 42
- PARAMETERS 42
- From Access Point 43
- 3.3.2 IP Configuration Menu 44
- (User Review Required)—ID of 45
- 3.4 CONFIGURING RADIO 48
- Figure 3-13. Skip Zones Menu 49
- 3.5 CONFIGURING THE SERIAL 50
- INTERFACES 50
- Serial Data Port 51
- (Serial-to-Serial example) 53
- (IP-to-Serial Example) 53
- COM port in 54
- 3.6 SECURITY CONFIGURATION 57
- 3.7 WIRELESS NETWORK MENU 59
- Figure 3-26. Remote Database 62
- 3.8 STATISTICS/EVENT LOG 64
- Wireless Packet 68
- Statistics 68
- Ethernet Packet 68
- 3.8.4 Radio Packet Statistics 69
- 3.8.5 Event Log Menu 69
- Time and Date 70
- Figure 3-34. Event Log Menu 70
- (Telnet/Terminal only)—IP 71
- 3.9 DEVICE INFORMATION MENU 72
- 3.10 MAINTENANCE/TOOLS 73
- 3.10.1Reprogramming Menu 74
- Upgrading the 76
- Transceiver 76
- Firmware 76
- LAN, or Terminal emulator 77
- 3.10.3 Ping Utility Menu 85
- 3.10.4Authorization Keys Menu 86
- MANAGEMENT 87
- REMOTE RADIO 87
- 4.1 INTRODUCTION 89
- COMMAND DESCRIPTION 90
- 4.2 UPGRADING REMOTE FIRMWARE 101
- CONFIGURATIONS 103
- Establishing a 105
- Connection 105
- Invisible place holder 106
- RemoteAccess Point 107
- COM port 108
- Remote 1 109
- Remote 2 109
- Remote 3 109
- Remote 4 109
- Access Point 109
- INSTALLATION 111
- 6.1 INSTALLATION 113
- 6.1.2 Site Selection 114
- High-gain Type 115
- Unity-gain Type 115
- CHART, on Page 113 120
- TROUBLESHOOTING & 123
- RADIO TESTS 123
- 7.1 TROUBLESHOOTING 125
- Management System 126
- LINK LED 130
- Statistics) 131
- TECHNICAL REFERENCE 133
- 8.1 DATA INTERFACE CONNECTORS 135
- 8.1.2 COM1 Port (AP, Remotes) 136
- 8.2 TECHNICAL SPECIFICATIONS 137
- DATA CHARACTERISTICS 138
- RADIO CHARACTERISTICS 138
- DEFINITIONS OF TERMS 141
- COM1 and COM2 Port of the 142
- IN CASE OF DIFFICULTY 147
Relacionado con productos y manuales para Redes Microwave Data Systems MDS entraNET 2400
(220 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.168 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales