Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 29)

MDS 05-4055A01, Rev. A MDS entraNET 900 System Guide 21

• LAN/ETH (Ethernet units)—On or blinks intermittently

• COM2—Blinks to indicate data communications

Table 2-2 provides details on the LED functions for Remotes and AP

radios.

Table 2-2. Transceiver LED Functions

2.6.1 Verifying Connectivity

Ethernet Remotes

If the radio network is operating properly based on observation of the

unit’s LEDs, you can use the

PING command from the AP to verify the

link integrity between the Access Point and an endpoint-device con-

nected to the Remote radio. Figure 2-8 shows the a typical arrangement

for this test.

NOTE: To conduct a Ping test, an Ethernet-enabled device must be

connected to the Remote, and it must have a compatible IP

address. Remote radios do not have an IP address and cannot

be verified directly using this method.

LED Label Activity Indication

LAN/ETH ON LAN or endpoint detected

Blinking Data TX/RX

OFF LAN not detected

COM1

(MGT System)

Blinking Data TX/RX

OFF No data activity

COM2 Blinking Data TX/RX

OFF No data activity

PWR ON Primary power (DC) present

Blinking Unit in “Alarmed” state

OFF Primary power (DC) absent

LINK

(Access Point)

ON Lights when radio has finished

its boot cycle. Remains lit.

LINK

(Remote)

ON Connected to AP

OFF Not connected to an AP

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 29