Microwave Data Systems MDS entraNET 2400 Especificaciones descargar pdf (Pagina 62)

54 MDS entraNET 900 System Guide MDS 05-4055A01, Rev. A

• Serial Configuration—Tool for configuring COM1/2

parameters, including: Port Mode, Baud Rate, Byte Format,

Seamless Mode, Interpacket Delay, and Buffer Size.

• Statistics—Presents packet throughput and retry data for

the selected Remote

• Remote Reprogramming—Menu for sending new firm-

ware images and specifying the image that will be active upon

re-boot.

Remote Database Menu

The Remote Database Menu (Figure 3-26) shows several parameters

related to the connected Remotes. is continuously updated at a refresh

rate of approximately 8 seconds.

Invisible place holder

Figure 3-26. Remote Database

• UnitID—The unit ID of the connected Remote.

• Conn State—Shows whether or not the Remote is connected

with the AP.

• AgeOut—Number of minutes before the entry ages out and is

removed from the table. Each AP maintains a table with the

addresses of the devices it communicates with. The AgeOut count-

down is restarted to its default setting every time a message to/from

that device is detected. If no trafﬁc with that device occurs, and it

does not respond to a ﬁnal handshake request, it then “ages out” of

the table.

An aged out Remote must reconnect before it is again included in

the table. (See “database timeout” on the Wireless Network Menu,

Figure 3-23 on Page 52.

• TX Pkts—Number of packets sent to this Remote.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 147 148

Sin comentarios

Microwave Data Systems MDS entraNET 2400 Especificaciones Pagina 62